We all know that the 2024 aluminum bar is generally preheated when it enters the extruder. According to experience, it needs to be heated to a certain solid solution temperature. However, it is not always necessary to reach the solid solution temperature in the 2024 aluminum bar preheating furnace as long as the 2024 aluminum bar is properly ingot cast and homogenized.Today 2024 aluminum bar manufacturer would like to introduce to you the problem of temperature measurement in the preheating area of 2024 aluminum bar.

Problems of temperature measurement in the preheating zone of 2024 aluminum bar:

1. Two-point thermocouple reading will be too low

2. The daily maintenance of two-point thermocouple is often neglected

3. Uniform heat treatment temperature is a key parameter of 2024 aluminum bar

4. Operators tend to overheat the 2024 aluminum bar

5. The extrusion rate tends to reduce the operator's fine tuning temperature at 2024 aluminum bar extrusion

The above is about the problem of temperature measurement in the preheating area of 2024 aluminum bar. If you need 2024 aluminum bar, please contact us.