The material of 5052 aluminum tube is soft. What should we pay attention to when using it?Next 5052 aluminum tube manufacturers to give you a detailed introduction.

1、 the 5052 aluminum tube cutting, do not cut too much, on the shrink and empty section and the end of the cracking part of the cutting can be done, pay attention to the cutting, do not oblique cutting, to put the 5052 aluminum tube in the cutting.

2、5052 aluminum tube material shelf should pay attention to, first check the surface of whether there is damage, and then check whether there are creases when cutting, such as the number of rod marks or shallow depth, should be ground into the shelf.

3、When using 5052 aluminum tube, the wall thickness shall be measured and recorded. If 5052 aluminum tube with stiff head is found, it shall be marked in a timely manner.

4、after the expansion of the pipe, but also to the appearance of 5052 aluminum tube can be checked, whether there are defects, if there are defects, to eliminate timely, if too many defects, can not be restored to the furnace to re-repair and grinding clean.

5、When the thermal expansion of 5052 aluminum, the thickness of the first three kinds of tube wall is measured, but also completed, after the expansion, the next measurement is made, and the velocity is adjusted by the expansion and temperature according to the change of these two measurement values.

The above are the matters needing attention when using 5052 aluminum tube. If you need 5052 aluminum tube, please contact us.