The 6061 aluminum plate needs to be cleaned after processing and forming, because the jet cleaning is relatively complex, so it needs to pay attention to a few things, next small make up to give you a detailed introduction, 6061 aluminum plate profile jet cleaning operation points.

1. The 6061 aluminum plate jet cleaning shall be carried out according to the operation specifications. The running state of the equipment shall be checked every day and the relevant process parameters shall be observed at all times.At the same time, the workpiece in the cleaning equipment to avoid stagnation for too long to avoid rust.

2. Attention must be paid to the quality of water washing during operation.In order to reduce the pollution of the relevant 6061 aluminum plate, so, we should first of all be able to minimize the workpiece with cleaning fluid, resulting in the next process is contaminated.At the same time, the multistage washing process should be taken into consideration as far as possible. In general, the multistage washing is carried out according to the two-stage washing process, and even pure water is used for cleaning in some special processes.However, it is important to note to all our operators that the maximum water contamination parameter for the latter stage washing should not exceed 10% of the previous stage cleaning workpiece, so that the concentration of residual liquid in the secondary jet cleaning of the workpiece can reach the original concentration of 1%.Finally, in the process of water washing, the water should be added in the way of countercurrent replenishment to achieve the purpose of water saving as much as possible.

3. Effectively control the foam during the cleaning process.The quality of 6061 aluminum plate cleaning agent does not depend on the number of foam, the focus should be the injection of cleaning agent to choose low bubble cleaning agent, otherwise, in the batch production of 6061 aluminum plate, there will be problems and can not be normal.

4. How to configure oil remover.When due to cleaning of 6061 aluminum plate, using a single set of cleaning effect is very poor, so, in 6061 in the production of aluminum plate usually adopts the multicomponent compound cleaner to cleaning of 6061 aluminum plate, so we can through the use of the strong alkali, weak alkali, polymer materials such as inorganic salts and surfactants proper matching configuration become compound cleaner, wash not only can give full play to their respective features, it is important to effectively improve the efficiency of washing.

The above is about the operation of jet cleaning 6061 aluminum plate, if you need 6061 aluminum plate can contact us.