After anodizing, 6061 aluminum plate has better effect, better processing and weather resistance, and better surface, bright, clean and beautiful. Then 6061 aluminum plate manufacturers use hanging tools in anodizing. What points should be paid attention to?I'm going to give you a detailed introduction.

1. According to shape and size, 6061 aluminum plate parts can be mounted on general or special hanging tools respectively.

2. Remove the old oxide film on the surface of the hanging tool before installing and hanging it.

3. When installing and hanging, the parts should be installed as fast as possible without any damage, especially the 6061 aluminum plate parts with thread processed by machinery.

4. The large skin shall be mounted with a medium-sized hanger. When swinging up and down in solution, bolts shall be tightened to prevent falling off.The main purpose of making the holes and mouths of box parts, tube parts and machining parts with blind holes up is to remove the gas generated by anodic oxidation and make the oxidation film of 6061 aluminum plate even.

5. When 6061 aluminum plate is made into small parts, it can be installed in rivet basket for anodic oxidation.First, the small parts for corrosion, light, clean before the basket.When oxidizing, can add some aluminum scraps appropriately when rivet installs basket, mix with rivet, gasket to install, basically be in order to increase conduction contact and reduce repair amount.

6. In order to avoid the collision between 6061 aluminum plate parts and parts, a certain interval should be maintained between each fixture.

This is the point to note when using the hanger for anodizing 6061 aluminum plate. If you need 6061 aluminum plate, please contact us.