We all know that the production of 2024 aluminum tube need to pay attention to a lot of circumstances, if not careful may occur bending phenomenon, then the next, 2024 aluminum tube manufacturers to tell you, 2024 aluminum tube production bending solution.

It is necessary to analyze the cause of the bending crack of 2024 aluminum tube. First, it should be ensured that the 2024 aluminum tube has a good heat treatment state, and the clamping die and bending wheel die should not be opposite.After excluding the factor of 2024 aluminum tube, check whether the pressure of the pressing die is too high and adjust the pressure to be appropriate.Ensure good lubrication of raw materials and inner wall of pipe to reduce resistance and friction, and take appropriate measures to avoid machine shaking and so on.

If the inside of the 2024 aluminum tube arc is wrinkled, corresponding measures should be taken according to the wrinkling position.If the front cut point is wrinkled, adjust the position of the raw material forward.If the back cutting point is wrinkled, anti-wrinkle block should be installed. The anti-wrinkle block is installed correctly, which can fit the 2024 aluminum tube mold well, and the pressure of pressing die (wheel) should be adjusted to make the pressure suitable;If the inside of the arc is full of folds, in addition to adjusting the die (wheel) to make the pressure is appropriate, but also to check the diameter and pitch of the raw material, the diameter is too small or wear serious to replace the raw material.

The above is the solution of bending in the production of 2024 aluminum tube. If you need to know the price of 2024 aluminum tube, please consult us.