6063 aluminum plate profile transmission line in a lot of factories can be seen, but in the process of use will also encounter a variety of problems, in which more problems is the transmission line deviation, the following 6063 aluminum plate manufacturers to give you an analysis of the specific reasons.

1, 6063 aluminum profile transmission line joint uneven tension control, in view of this development, you can constantly adjust the driving drum or change the tension on both sides of the drum to eliminate, unable to adjust the belt.

2.6063 Uneven guide force on both sides of the aluminum profile conveying line: Uneven force on both sides of the guide force leads to different resistance on both sides of the belt, resulting in belt deviation. This situation is relatively easy to deal with, as long as both sides of the guide force can be adjusted.

As shown in FIG. 3, the tension adjustment mechanism.When the belt is running, if the deviation of the unified side load under heavy load means that the tightness of the belt is not the same on both sides, the belt should be tightened and not loosened according to the law, and the weight of the screw or tensioning mechanism should be adjusted. If the left and right belts are deviated and have no definite direction, the belt should be relaxed and the tensioning mechanism should be adjusted.

4. If there is material sticking to the 6063 aluminum profile conveying line system locally, a belt assembly line will run off-track.Therefore, before and after use should check whether there are materials on the conveyor belt, to be cleaned in a timely manner.

The above is the introduction of the cause of deviation of 6063 aluminum plate profile transmission line. If you need 6063 aluminum plate, please contact us.