The wrong side of 5083 aluminum tube is often encountered in the production of the problem, that this time need to find the cause of the wrong side in time, otherwise it will affect the production quality of the aluminum tube, the next 5083 aluminum tube manufacturer will talk about the cause of 5083 aluminum tube wrong side.

In the production of 5083 aluminum pipe diameter pipe, the wrong side is often occurred, the main reasons may be:

1. The strip and the important factor are the Angle errors on the outside of the steel.The camber Angle of 5083 aluminum tube will change different shapes, so as to change the welding gap, there will be slit, wrong side.Seriously affecting the quality of the 5083 aluminum tube, and therefore, the observed strip camber coil, by controlling the vertical roll scissors, then makes the continuous removal of the shape of the steel during the production process of the disc camber control and correction is reduced to produce the curved sickle back in an effective manner.

2. Because the shape and dimensional precision of the end of the strip without trimming is not allowed, because the 5083 aluminum tube is prone to bending to the wrong side handling due to having a ridge.

3, aluminum head and tail butt welding seam residual height is relatively large, in the molding development process, if not properly handled, it is likely to cause a greater impact of the wrong side.

4. The edge of the belt in poor conditions is also an important reason for the wrong side.

The above is the introduction of the cause of the 5083 aluminum tube misalignment. If you need 5083 aluminum tube, please contact us.